Initial wipe plugin? - Plugins - OctoPrint Community Forum

I am trying to find a plugin that will initiate a better cleaning line than what cura provides and one that would make the line along the x and y. If a pluggin isn't the answer is there a geode fix I could put into octoprint so it is used with all my slicers? As I read my own post I begin to feel dumb. I think that if I used: G92 E0 ;Reset Extruder G1 Z2.0 F3000 ;Move Z Axis up G1 X10.1 Y20 Z0.28 F5000.0 ;Move to start position G1 X10.1 Y200.0 Z0.28 F1500.0 E15 ;Draw the first line G1 X10.

How to access OctoPrint over The Internet with AstroPrint (from anywhere!) - AstroPrint

The 10 Best OctoPrint Plugins

OctoPrint/CONTRIBUTING.md at master · OctoPrint/OctoPrint · GitHub

1.8.6 > 1.9.0rc2 went very bad - unable to start octoprint. no new log update on start attempt - Get Help - OctoPrint Community Forum

Solved]I need some help with my plugin - Development - OctoPrint Community Forum

Issue with Enclosure plugin - Plugins - OctoPrint Community Forum

How to Set Up OctoPrint on Raspberry Pi 4

Setting Up OctoPrint and its Plugins

The (in)secure story of OctoPrint - Cybersecurity and research blog

I just installed OctoPrint 1.3.12/OctoPi 0.17.0 and the Plugin Manager can't find pip, what's up? - FAQ - OctoPrint Community Forum

Octoprint setup on MK4/ MK3.9 / XL

Setting up Octo Print on Windows - Get Help Guides - Octo Print Community Forum - ' We stand with - Studocu